Northern Telecom NAC Installation Manual page 233

6-32 New software installations
Procedure 6-1 (continued)
New installation of the NAC 2 system: customer-installed software
Step Installer's action and system's response
39 Before logging in, ensure that the installation was successful. Review the NAC error
log for any fatal messages.
Log in as maint and refer to the NAC 2 System Administration and Maintenance
Guide (NTP 553
running" chapter, "Diagnostics" section, "View NAC error log" subsection for more
information.
40 If the system was installed correctly, go to Step 41.
If the system was not installed correctly, you must reinstall it. Ensure no errors
occurred within the steps you want to skip. If you are unsure, restart the
reinstallation from the beginning. If the errors persist, contact your Northern Telecom
distributor.
41 Insert a new blank tape into the tape drive for daily backup. Ensure that the write-
protect tab on the blank cartridge tape is set to write enabled to allow the system to
write information on the tape (refer to Figure 5-1). The importance of backups is ex-
plained in the "Software installation overview" chapter, "Backups" section.
42 Login as precut to view the NAC Training Mode screen.
Refer to the "Operating modes" chapter for the correct procedure to switch from
Training mode to Precutover mode. Refer to the "Operating modes" chapter,
"Switching from Training mode to Precutover mode" procedures for further
instructions on how to transfer from Training mode to Precutover mode.
553-4011-110 Standard 1.0 November 1994
- -
4011 510), "Maintenance and administration programs: System
—end—