Precutover Mode - Northern Telecom NAC Installation Manual

Precutover mode

Before switching to Precutover mode, ensure the following are ready:
1 Supervisors and agents are trained and ready to use the NAC system.
2 All workstations are logged out.
Switching to Precutover mode is an irreversible change (unless the software
is reinstalled). To switch to the Precutover mode, follow the instructions
given in the correct precutover to product procedure for your system.
To switch from Training to Precutover mode in a NAC 2 system, follow
Procedure 10-2.
In the Precutover mode, the database can be built in preparation for actual
NAC operations. Once the system database is set up, you can convert to the
Product mode. This is the operational mode where typical NAC operations
occur.
Network Administration Center (NAC) Installation Guide Product release 2
Operating modes 10-5