Interconnect Input/Output Cables - Northern Telecom NAC Installation Manual

3-30 Hardware installation

Interconnect input/output cables

Table 3-5
Interconnect input/output cables
ENG code
NT7D47DA
NT7D58CA
NT7D79BA
553-4011-110 Standard 1.0 November 1994
NAC 2 interconnect cables exit from the rear of the transition
modules/cards and terminate on the Application Equipment Module's
die-cast input/output panel via a custom input/output panel and
radio-filtered connectors.
Table 3-5 lists all of the interconnect I/O cables. Figure 3-7 shows cabling
schematics, which identify the cables and devices which must be connected
for a system.
The term "input/output connector panel" refers to the Generic I/O panel.
Application
Carries input/output
between the MVME712M
transition card and the
Input/Output connector
panel (Ethernet).
Carries input/output
between the input/output
connector panel (Card 1,
Conn 4) and the
MVME712M transition
board (Serial Port 4)
Carries input/output
between the input/output
connector panel (Card 1,
Conn 1–3, modem and
SDI Link) and the
MVME712M transition
board (Serial Ports 1,2 and
3).
Cable and connector
15-pin (male) Ethernet to
15-pin (female) Ethernet
15-pin (female) high
density D-sub to 25-pin
(male) round subminiature
D-style
9-pin (male) to 25-pin
(male) flat subminiature
D-style
—continued—
style
Length
35.5 cm
(14 inches)
35.5 cm
(14 inches)
35.5 cm
(14 inches)