Table of Contents
Advertisement
Adding MVME332XT eight-channel asynchronous boards
Before inserting any additional cards into the NAC 2 system, ensure that
each card's switch settings match those given in Table 3-2.
1
Shut down the NAC 2 software. Ensure that the I/O Port
Reconfiguration on System Restart is enabled.
Refer to NAC 2 System Administration and Maintenance Guide (NTP
553-4011-510), "Maintenance and administration programs: system
running" chapter, "Shut down the system" section for instructions on
shutting down your Meridian MAX system.
Refer to NAC 2 System Administration and Maintenance Guide (NTP
553-4011-510), "Maintenance and administration programs: system
shut down" chapter, "Restart and Power Down System Utilities" section
for instructions to enable the I/O Reconfiguration on System Restart
feature.
2
Secure the NAC system for power down.
Refer to NAC 2 System Administration and Maintenance Guide (NTP
553-4011 - 510), "Maintenance and Administration programs: system
shut down" chapter, "Restart and Power Down Utilities" section,
"Secure the System for Power Down" subsection for more information.
3
Remove the front and rear panels of the Application Equipment Module
(AEM).
4
Power down the application module (AM). The circuit breaker (CB) is
located at the left of the AEM.
5
To remove an existing MVME332XT board, locate the existing card that
needs switch settings verified or needs to be replaced. Use a Phillips
screwdriver to remove the top and bottom retaining screws which keep
the card in place. Press up on the card's top release lever while
pressing down on the bottom card release lever. When enough
pressure is applied, the card pushes itself out about a quarter of an
inch. Carefully pull the card out of the slot and set it aside.
6
To add additional MVME332XT eight-channel asynchronous boards to
the NAC, remove the face plates covering the empty card slots
specified in Table 3-8.
Network Administration Center (NAC) Installation Guide Product release 2
Hardware installation 3-43
Advertisement
Table of Contents
