Northern Telecom NAC Installation Manual page 301

Procedure 9-1 (continued)
Platform upgrade from a NAC 1 system to a NAC 2 system
Step Installer's action and system's response
29 The system displays the hardware configuration.
NAC has detected that you are running the following hardware configuration:
CPU
Memory
Hard Disk
Tape Drive
If this configuration does not match your configuration,
please type "n" to the following question. The installation
will abort. Please call your service representative for
further assistance.
–––> Do you wish to install the hardware configuration specified
above (y/n) ?
30 If you want to abort the installation, enter n, followed by {RETURN}. If you want to
install the hardware configuration, enter y, followed by {RETURN}. The system then
displays a menu.
The NAC Software Installation Menu
-–––––––––––––––––––––––––––––––––
1 New Installation
2 Installation Upgrade
3 Application Upgrade
4 Platform Upgrade
–––> Enter a number to select the type of installation/upgrade desired, or enter q to quit :
31 Since this procedure is a platform upgrade, enter 4, followed by {RETURN}.
Will perform a Platform Upgrade.
–––> Do you wish to restart a previously-aborted installation (y/n)?
Network Administration Center (NAC) Installation Guide Product release 2
: 167 Card
: 32 Mb
: 1.2 Gb (Seagate ST11200N)
: 600 Mb (Teac MT–2ST/F50B)
—continued—
Platform upgrades 9-9