Northern Telecom NAC Installation Manual page 242

Procedure 6-2 (continued)
New installation of the NAC 2 system: factory-installed software
Step Installer's action and system's response
13 Enter y, followed by {RETURN}.
The system displays the following message:
The operating system will shut down and restart, and then NAC will restart.
Please wait for system to reboot.
The system displays a number of messages as it shuts down. After shutdown the
system automatically reboots.
Console Login:
14 Before logging in, ensure that the installation was successful. Review the NAC error
log for any fatal messages.
Login as maint and refer to the NAC 2 System Administration and Maintenance
Guide (NTP 553
running" chapter, "Diagnostics" section, "View NAC error log" subsection for more
information.
15 If the system was installed correctly, go to Step 16.
If the software release for your system is different than what you purchased, your
system was not installed correctly. Contact your Northern Telecom distributor.
If the number of ports enabled for your system is different than what you purchased,
your MVME332XT boards could be inserted incorrectly or the board settings could
be incorrect. Refer to the "MVME332XT eight-channel asynchronous board" section
in the "Hardware installation" chapter for more information. Return to Step 1 and try
this procedure again. If the installation fails, contact your Northern Telecom
distributor.
16 Insert a new blank tape into the tape drive for daily backup. Ensure that the write-
protect tab on the blank cartridge tape is set to write enabled to allow the system to
write information on the tape. The importance of backups is explained in the "Soft-
ware installation overview" chapter, "Backups" section.
Network Administration Center (NAC) Installation Guide Product release 2
- -
4011 510), "Maintenance and administration programs: System
—continued—
New software installations 6-41