Netcomm Smartmodem M7F - Northern Telecom NAC Installation Manual

4-44 Peripheral devices

NetComm SmartModem M7F

Figure 4-13
NetComm SmartModem M7F modem switch settings
1
OFF
ON
Procedure 4-3
Configuring the NetComm SmartModem M7F for remote diagnostics
Step Action
1 Connect a workstation to the modem
with a straight through NT1R03Dx or
NT1R03Ex cable.
553-4011-110 Standard 1.0 November 1994
Figure 4-12 illustrates the connection between the NAC remote diagnostics
port and a remote workstation using the NetComm SmartModem M7F.
To properly set up the NetComm modem for remote diagnostics, ensure the
modem's switch settings match those shown in Figure 4-13. The same
switch settings should be used at both the remote end and the NAC end.
Note: There are two buttons located on the front panel of the modem:
Mode and Talk/Data. For use with the NetComm modem, the
Talk/Data button should be pressed.
FRONT
2 3 4 5
Complete the steps in Procedure 4-3 to configure the NetComm modem for
remote diagnostics.
6
UP
DOWN
Response
—continued—
REAR
DSR DTR RTS CD