Northern Telecom NAC Installation Manual page 75

3-50 Hardware installation
Procedure 3-1 (continued)
Configuring the MVME167-34 card
Step Installer's action and system's response
If your card was preset in the factory, the following message appears.
Autoboot in progress... To abort hit <BREAK>
4 Press the {BREAK} key if your MVME167-34 card was preset in the factory.
––Break Detected––
The following menu appears if your card was not preset in the factory.
1) Continue System Start Up
2) Select Alternate Boot Device
3) Go to System Debugger
4) Initiate Service Call
5) Display System Test Errors
6) Dump Memory to Tape
Enter Menu #:
5 If your card was not preset in the factory, enter 3 to select the "Go to System
Debugger" option.
The system displays the following prompt:
167–Diag>
If your card was preset in the factory, the system displays the following prompt
instead:
167–Bug>
553-4011-110 Standard 1.0 November 1994
—continued—