Northern Telecom NAC Installation Manual page 261

8-4 Software reinstallations and upgrades
Procedure 8-1 (continued)
Software reinstallation or upgrade to a NAC 2 system
Step Installer's action and system's response
8 Power up the module. The power switch is located on the left-hand side of the AEM
module. The upper switch controls the power for the application module in the left
side of the AEM, while the lower switch controls the power for the right side.
The system displays the copyright and hardware configuration information. Your sys-
tem messages may differ.
Copyright Motorola Inc. 1988 – 1993, All Rights Reserved
MVME167 Debugger/Diagnostics Release Version 1.5 – 02/14/93
COLD Start
Local Memory Found =02000000 (&33554432)
MPU Clock Speed = 33Mhz
Autoboot in progress... To abort hit <BREAK>
9 Press {BREAK} to stop the hard disk load and begin the tape load.
Note: {F5} on the VT420 is the {BREAK} key.
––Break Detected––
167–Bug>
10 Wait for the tape to rewind. The tape drive light turns off when the tape is rewound.
At the previous prompt, enter bo 0,40 followed by {RETURN}.
Booting from VME167, Controller 0, Drive 40
Loading: Operating System
Volume: V/68
553-4011-110 Standard 1.0 November 1994
—continued—