Northern Telecom NAC Installation Manual page 141

Procedure 4-3 (continued)
Configuring the NetComm SmartModem M7F for remote diagnostics
Step Action
2 Connect the workstation and the
modem to their power sources.
3 Power up the workstation and the
modem.
4 Enter the following commands on the
workstation keyboard, pressing
{ENTER} after each command.
atz
at&f
ats0=1
at&d0
at&c1
at\n3
at\q3
at&w
5 Power down the workstation and the
modem.
6 Disconnect the workstation from the
modem.
7 Connect the modem directly to the NAC
generic I/O panel using an NT7D61Ax
modem cable. Make sure the modem is
connected to the telephone system with
an RJ-11 cable/connector.
Network Administration Center (NAC) Installation Guide Product release 2
Response
OK
OK
OK
OK
OK
OK
OK
OK
—continued—
Peripheral devices 4-45