Table of Contents
Advertisement
UDS 2440
Procedure 4-9
Configuring the UDS 2440 modem for dial-up supervisor—remote end
Step
Action
1
Connect a workstation to the modem
with a straight through NT1R03Dx or
NT1R03Ex cable.
2
Connect the workstation and the
modem to their power sources. Make
sure the modem is connected to the
telephone system with an RJ-11
cable/connector.
3
Power up the workstation and the
modem.
4
Enter the following commands on the
workstation keyboard, pressing
{ENTER} after each command.
atz
at&f
ats0=1
Figure 4-14 shows the front and rear view of the UDS 2440 dial-up
supervisor modem. This modem connects to the AM's multiport cable
using an NT7D99AA cable.
The UDS 2440 modem does not contain any internal switch settings.
Complete Procedure 4-9 to configure the UDS 2440 modem for dial-up
supervisor.
NAC automatically configures remote supervisor modems connected at the
NAC end. The cable connecting the NAC AM's VME multiport cable and
the UDS 2440 modem is the modem cable NT7D99AA.
Network Administration Center (NAC) Installation Guide Product release 2
Response
OK
OK
OK
—continued—
Peripheral devices
4-65
Advertisement
Table of Contents
