Table of Contents
Advertisement
Factory-installed software
Procedure 6-2
New installation of the NAC 2 system: factory-installed software
Step
Installer's action and system's response
1
Before beginning the software installation, ensure that the MVME167-34 card has
been configured correctly. Refer to the "Hardware installation" chapter for more
information on configuring the MVME167-34 card.
2
Power up the module. The power switch is located on the left-hand side of the AEM
module. The upper switch controls the power for the application module in the left
side of the AEM, while the lower switch controls the power for the module in the right
side.
The system displays the copyright and hardware configuration information. The mes-
sages below may differ from your system messages.
Copyright Motorola Inc. 1988 – 1993, All Rights Reserved
MVME167 Debugger/Diagnostic Release Version 1.5 – 02/14/93
COLD START
Local Memory Found =02000000 (&33554432)
Network Administration Center (NAC) Installation Guide Product release 2
To perform the following procedure, you need the NAC 2 application tape
and the generic operating system tape.
—continued—
New software installations
6-33
Advertisement
Table of Contents
