Northern Telecom NAC Installation Manual page 158

4-62 Peripheral devices
Procedure 4-7
Configuring the NetComm SmartModem M7F for dial-up supervisor—remote end
Step Action
1 Connect a workstation to the modem
with a straight through NT1R03Dx or
NT1R03Ex cable.
2 Connect the workstation and the
modem to their power sources. Make
sure the modem is connected to the
telephone system with an RJ-11
cable/connector.
3 Power up the workstation and the
modem.
4 Enter the following commands on the
workstation keyboard, pressing
{ENTER} after each command.
atz
at&f
ats0=1
at&d0
at&c1
at\n3
at\q3
at&w
5 Use the Hayes AT command "atdt####"
for touch-tone dialing and "atdp####"
for pulse dialing to dial the required
number.
(where #### is the telephone number of
the NAC modem)
553-4011-110 Standard 1.0 November 1994
Response
OK
OK
OK
OK
OK
OK
OK
OK