Uds 2440 - Northern Telecom NAC Installation Manual

UDS 2440

Procedure 4-13
Configuring the UDS 2440 modem for network link
Step Action
1 Connect a workstation to the modem
with a straight through NT1R03Dx or
NT1R03Ex cable.
2 Connect the workstation and the
modem to their power sources.
3 Power up the workstation and the
modem.
4 Enter the following commands on the
workstation keyboard, pressing
{ENTER} after each command.
atz
at&f
at&d3
at&s1
at&c1
Figure 4-14 shows the front and rear view of the UDS 2440 network link
modem. This modem connects to the AM's multiport cable using an
NT7D99AA cable.
The UDS 2440 modem does not contain any internal switch settings.
Complete Procedure 4-13 to configure the UDS 2440 modem for network
link.
Network Administration Center (NAC) Installation Guide Product release 2
Response
OK
OK
OK
OK
OK
—continued—
Peripheral devices 4-85