Table of Contents
Advertisement
4-86 Peripheral devices
Procedure 4-13 (continued)
Configuring the UDS 2440 modem for network link
Step
Action
at&z0=t#######
####### must be replaced with the
correct telephone number for the
Meridian MAX node.
at&w
5
Power down the workstation and the
modem.
6
Disconnect the workstation from the
modem.
7
Connect the modem directly to the NAC
multiport cable using an NT7D99AA
modem cable. Make sure the modem is
connected to the telephone system with
an RJ-11 cable/connector.
8
Power up the modem.
Ven-Tel 2400 Plus II
553-4011-110 Standard 1.0 November 1994
To properly set up the Ven-Tel 2400 Plus II modem for use as a network
link, ensure that the switch settings match those shown in Figure 4-32.
Response
OK
OK
If your NAC system is powered up and
fully functional, you should see the LED
labelled "TR" light up on the front panel
of the modem. If the "TR" LED does not
light up, retry this procedure. If the light
still does not appear, contact your
Northern Telecom representative.
—end—
Advertisement
Table of Contents
