Northern Telecom NAC Installation Manual page 208

Procedure 6-1 (continued)
New installation of the NAC 2 system: customer-installed software
Step Installer's action and system's response
13 Remove the Application tape and insert the OS tape. Wait for the tape to rewind. The
tape drive light turns off when the tape is rewound.
If the OS tape is in the tape drive and the tape drive light is off, enter y, followed by
{RETURN}.
14 The system displays the hardware configuration.
NAC has detected that you are running the following hardware configuration:
CPU
Memory
Hard Disk
Tape Drive
If this configuration does not match your configuration,
please type "n" to the following question. The installation
will abort. Please call your service representative for
further assistance.
–––> Do you wish to install the hardware configuration specified
above (y/n) ?
15 If you want to abort the installation, enter n, followed by {RETURN}. If you want to
install the hardware configuration, enter y, followed by {RETURN}. The system then
displays a menu.
The NAC Software Installation Menu
-–––––––––––––––––––––––––––––––––
1 New Installation
2 Installation Upgrade
3 Application Upgrade
4 Platform Upgrade
–––> Enter a number to select the type of installation/upgrade desired, or enter q to quit :
Network Administration Center (NAC) Installation Guide Product release 2
: 167 Card
: 32 Mb
: 1.2 Gb (Seagate ST11200N)
: 600 Mb (Teac MT–2ST/F50B)
—continued—
New software installations 6-7