Northern Telecom NAC Installation Manual page 216

Procedure 6-1 (continued)
New installation of the NAC 2 system: customer-installed software
Step Installer's action and system's response
*
* You must REBOOT the system and allow it to autoboot from the hard *
* disk. Please power off the system now.
*
* Please allow 20 seconds between turning the power off and on again*
* to allow the power to reset.
*
27 After you turn off the power for the module, wait 20 seconds, and turn the power on
again; the system automatically reboots. The messages below may differ from your
system messages.
Copyright Motorola Inc. 1988 – 1993, All Rights Reserved
MVME167 Debugger/Diagnostics Release Version 1.5 – 02/14/93
COLD START
Local Memory Found =02000000 (&33554432)
MPU Clock Speed =33Mhz
Network Administration Center (NAC) Installation Guide Product release 2
The NAC 2 product has been installed on the hard disk.
You may now remove the tape from the tape drive.
*
*
*
***************************
**** REBOOT THE SYSTEM ****
***************************
—continued—
New software installations
*
*
6-15