Table of Contents
Advertisement
8-2 Software reinstallations and upgrades
Software reinstallation or upgrade for a NAC 2 system
553-4011-110 Standard 1.0 November 1994
Use Procedure 8-1 if you want to perform one of the following procedures.
Reinstallation: You are currently running NAC 2 and want to install
new NAC 2 system software to incorporate operating system and
database changes.
Application upgrade: You are currently running NAC 2 and want to
install new NAC 2 software to change your NAC system's secondary
language.
Note: To change your default language, refer to the "Operating
modes" chapter, "Changing the default language" section.
After the system reboot following the operating system and application tape
installation, you can follow one of two paths in this procedure.
Ensure that the proper hardware procedures have been completed before
beginning this procedure.
If you do not have a backup tape or do not want to install your backup data
onto the new system, you can switch the installation upgrade to a new
installation. This alteration allows you to skip over the steps where the
backup data tape is inserted and loaded onto the system.
If you want to load your backup data, continue the installation as an
installation upgrade and follow the screen prompts and messages to load
the backup tape.
To perform the following procedure, you need the NAC application tape
and the generic operating system tape.
Advertisement
Table of Contents
