ma_dr_f6-cu-k-inst-20144795_en
Selection of our units in view of their suitability for the intended use must be done
generally by the user.
Tests can only be carried out within the scope of the intended end use of the
product (Application) by the Customer. They must be repeated, even if only
parts of hardware, software or the unit adjustment are modified.
1.5 Copyright
The
customer
may use the instructions for use as well as further documents or
parts from it for internal purposes. Copyrights are with KEB Automation KG and re-
main valid in its entirety.
Other wordmarks and/or logos are trademarks (™) or registered trademarks (®) of
their respective owners.
1.6 Validity of this manual
This part of the instruction manual describes the implemented control card. It
– is only valid in conjunction with the instructions for use of the power part.
– contains only supplementary safety instructions.
– if certain functions or properties are version-dependent, this is indicated at the
appropriate place. The version number of the COMBIVERT can be found in
brackets after the material number.
1.7 Target group
The instructions for use is determined exclusively for electrical personnel. Electrical
personnel for the purpose of this instruction manual must have the following quali-
fications:
– Knowledge and understanding of the safety instructions.
– Skills for installation and assembly.
– Start-up and operation of the product.
– Understanding of the function in the used machine.
– Detection of hazards and risks of the electrical drive technology.
– Knowledge about
– Knowledge of national accident prevention regulations (e. g.
3).
DIN IEC
60364-5-54.
Introduction | 1
DGVU Regulation
9