Stop Bits
Purpose:
Sets the number of stop bits on the communications port.
Note: You must select the communications port and protocol before you set the
parameters that define the protocol. For help, see "Communications Protocol,
Configure" earlier in this chapter.
Default:
1 stop bit
Syntax:
ICdata
Acceptable values for data are:
1
2
Scan:
One of these bar codes:
1 Stop Bit
*$+IC1*
*$+IC1*
2 Stop Bits
*$+IC2*
*$+IC2*
NF
1 stop bit
2 stop bits
BC
Configuration Command Reference
12
12-91