Eom (End Of Message) - Intermec JANUS 2020 User Manual

EOM (End of Message)

Purpose: Attaches an EOM to the end of a data block to indicate the end of data
transmission to and from a reader. You can disable the EOM transmit and
receive characters, define EOM transmit and receive to the same characters, or
define EOM transmit and receive to different characters.
Note: You must select the communications port and protocol before you set the
parameters to define that protocol. For help, see "Communications Protocol,
Configure" earlier in this chapter.
EOM Transmit and Receive are set to CR (0DH) and LF (0AH) (carriage return
Default:
line feed)
Syntax: PF
PFdata
PI
PIdata
PJ
PJdata
where data can be one or two ASCII characters.
Scan: To disable EOM, scan one of these bar codes:
Disable EOM Transmit and Receive
*$+PF*
*$+PF*
Disable EOM Receive Only
*$+PJ*
*$+PJ*
Or: To set EOM Transmit and Receive to the same ASCII character:
1. Scan this bar code:
NF
Disable EOM transmit and receive
Enable EOM transmit and receive
Disable EOM transmit only
Enable EOM transmit only
Disable EOM receive only
Enable EOM receive only
Enter Accumulate Mode / Enable EOM Transmit and Receive
*+/$+PF*
*+/$+PF*
BC
Configuration Command Reference
Disable EOM Transmit Only
*$+PI*
*$+PI*
12
12-53