Eom (End Of Message) - Intermec Janus 2020 User Manual

EOM (End of Message)

Purpose: Attaches an EOM to the end of a data block to indicate the end of data
transmission to and from a reader. You can disable the EOM transmit and
receive characters, define EOM transmit and receive to the same characters, or
define EOM transmit and receive to different characters.
Note: You must select the communications port and protocol before you set the
parameters to define that protocol. For help, see "Communications Protocol,
Configure" earlier in this chapter.
Default: EOM Transmit and Receive are set to CR (0DH) and LF (0AH) (carriage return
line feed)
Syntax: PF
PFdata
PI
PIdata
PJ
PJdata
where data can be one or two ASCII characters.
Scan: To disable EOM, scan one of these bar codes:
Disable EOM Transmit and Receive
*$+PF*
*$+PF*
Disable EOM Receive Only
*$+PJ*
*$+PJ*
Or: To set EOM Transmit and Receive to the same ASCII character:
1. Scan this bar code:
NF
Disable EOM transmit and receive
Enable EOM transmit and receive
Disable EOM transmit only
Enable EOM transmit only
Disable EOM receive only
Enable EOM receive only
Enter Accumulate Mode / Enable EOM Transmit and Receive
*+/$+PF*
*+/$+PF*
BC
Configuration Command Reference
Disable EOM Transmit Only
*$+PI*
*$+PI*
12
12-53