Data Bits - Intermec Janus 2020 User Manual

Data Bits

Purpose: Sets the number of data bits the reader uses when communicating with another
device (i.e., host computer).
Note: You must select the communications port and protocol before you set the
parameters to define that protocol. For help, see "Communications Protocol,
Configure" earlier in this chapter.
Default: 7
Syntax: IIdata
Acceptable values for data are:
7
8
Scan: One of these bar codes:

7 Data Bits

*$+II7*
*$+II7*
8 Data Bits
*$+II8*
*$+II8*
NF
7 data bits
8 data bits
BC
Configuration Command Reference
12
12-43