Moving The Batch Files; Using An External Power Supply - Intermec Janus 2020 User Manual

D
BC
NF
Software Utility Reference
For more help, see these chapters:
Chapter 3, "Learning About the Software" Describes how to install Auto-Loader,
explains why you must use special utilities to change drive C, and includes
instructions for executing the commonly used batch files.
Chapter 8, "Preparing the Reader for International Use" Describes how to use
Auto-Loader to configure the reader to operate in a DOS National Language
Support (NLS) language: French, German, Italian, or Spanish.

Moving the Batch Files

The batch files are customized for the drive and directory where you installed
them. To move the batch files, you must reinstall Auto-Loader. For help, see
"Installing Auto-Loader on Your Host Computer" in Chapter 3.

Using an External Power Supply

When you use Auto-Loader, you must connect an external power supply to the
communications dock or optical link adapter. Auto-Loader uses MkImage and
PutImage software. Because PutImage requires an external power supply,
Auto-Loader also requires an external power supply.
Caution
The reader should be powered by an AC power source when you use the
PutImage command in case the battery pack goes low while the flash is being
erased. If the power goes down when using PutImage, the reader locks up and
the system flash must be reloaded from the Boot Loader menu and you will
lose data.
Conseil
Il faut alimenter le lecteur par une source de courant AC lors de l'exécution de
la commande PutImage dans le cas où le jeu de piles s'affaiblit pendant
l'effacement du flash. Si le courant est coupé lors de l'exécution de PutImage,
le lecteur se verrouille, le flash système doit être rechargé du menu d'amorçage
(Boot Loader) et vous perdez des données.
D-11