Laser On And Off - Intermec Janus 2020 User Manual

Laser On and Off

The Laser On and Off commands are the same as pulling and releasing the
scanner trigger. After a Laser On command, the scanner operates differently
depending on the scanner mode and scanner trigger configuration settings:
• If you configure the reader to use One-Shot Scanner mode and level
• If you configure the reader to use Automatic Scanner mode and level
Note: Intermec does not recommend that you use a Laser On or Off command with the
Scanner Trigger command set to edge triggering.
Purpose: The Laser On command is the same as pulling the scanner trigger.
From Host:
/.
Keypad: Not supported
IRL Command: Z"/."
Not supported
Scan:
Purpose: The Laser Off command is the same as releasing the scanner trigger. Its effect
depends on the scanner and trigger mode configuration settings as described
above.
From Host:
/%
Keypad: Not supported
IRL Command: Z"/%"
Scan: Not supported
triggering, the scanner automatically turns off after a good read of a bar
code label, or after the scanner timeout period elapses.
triggering, the scanner remains on after a good read of a bar code label. You
use the Scanner Timeout command or the Laser Off command to turn off
the scanner.
BC
NF
Reader Command Reference
11
11-13