4. Scan this bar code:
Beep Frequency
Purpose:
Defines the individual frequencies of the default reader beeps. There are two
types of beeps:
• Low beep
• High beep
Default:
1000 Hz for the low beep
2000 Hz for the high beep
Syntax:
BFdata
Acceptable values for data are from 20 to 20,000 Hz (20 KHz).
Note: If you set the frequency outside the range of 100 Hz to 10,000 Hz, the beeps are
inaudible.
Scan:
1. Scan this bar code:
2. Scan a numeric value for data in Hz from these bar codes:
NF
Exit Accumulate Mode
*-/*
*-/*
Enter Accumulate Mode / Change Beep Frequency
*+/$+BF*
*+/$+BF*
*0*
*0*
*2*
*2*
*4*
*4*
BC
Configuration Command Reference
*1*
*1*
*3*
*3*
*5*
*5*
12
12-13