JANUS 2020 Hand-Held Computer User's Manual
Using LOAD_USA
LOAD_USA creates an image file that contains only the three startup files in
the C_FILES\COMMON directory: AUTOEXEC.BAT, AUTOINST.BAT, and
CONFIG.SYS. Then LOAD_USA loads the image file onto drive C, deleting all
the files currently on drive C.
Here is the syntax for LOAD_USA:
Note: If you installed Auto-Loader for a DOS NLS country, the LOAD_USA batch
file is not installed.
USING LOADLANG
LOADLANG creates an image file that contains only the three startup files in
the C_FILES\COMMON directory. Then LOADLANG loads the image file
onto drive C, deleting all the files currently on drive C.
The LOADLANG command also edits AUTOEXEC.BAT and CONFIG.SYS to
support the DOS NLS language you specified when you installed Auto-Loader.
For help, see Chapter 8, "Preparing the Reader for International Use."
Here is the syntax for LOADLANG:
Note: If you installed Auto-Loader for a DOS NLS country, the LOADLANG batch
file is installed instead of the LOAD_USA batch file.
Using LOADADD
LOADADD adds or replaces files on the reader's drive C without overwriting
all of the files of drive C. You can also use LOADADD to configure the reader
to operate in a DOS NLS language.
There are two LOADADD commands:
•
•
D-12
load_usa
loadlang
loadadd nls
loadadd path \ filename [ path \ filename path \ filename... ]
where:
path
is the drive and directory of the file to load.
is the name of the file to load.
filename
You can specify more than one file or use path\*.* to load all the files from a
directory.
BC
N F