Intermec Janus 2020 User Manual page 328

JANUS 2020 Hand-Held Computer User's Manual
When using the Substitute command on the reader, you can:
• add the Substitute command to the AUTOEXEC.BAT file so that the drive
• execute the Substitute command at the DOS prompt to temporarily change
• execute the Substitute command in a batch file.
These commands do not work on drives used in the Substitute command:
CHKDSK
DISKCOMP
DISKCOPY
FORMAT
For a complete description of the Substitute command, see any DOS 5.0 user's
manual or guide.
To use the Substitute command
1. Insert a PC card in the PC card drive. For example, insert a PC card in the
Caution
You must insert a PC card in each PC card drive or you will get a critical error
message when the reader executes the Substitute command.
Conseil
Vous devez insérer une carte PC dans chaque lecteur PC. Sinon, un message
d'erreur critique s'affiche lorsque le lecteur exécute la commande Substitute.
2. Type the Substitute command and press
10-32
letter assignments are changed each time the reader is booted.
the drive letter assignments.
LABEL
MIRROR
RECOVER
SYS
JANUS 2020 PC card drive.
Note: DOS requires that a drive is present when you execute the Substitute
command.
subst drive : substitute_drive :
where substitute_drive is the letter you are assigning to the drive. Include a
colon after each drive letter in the command.
For example, on a J2020 with software version 2.1, use this command to
substitute drive G with drive E:
subst g: e:
BC
N F
e
.