Postamble - Intermec Janus 2020 User Manual

JANUS 2020 Hand-Held Computer User's Manual

Postamble

Purpose: Sets the postamble that is appended to any data you scan with the reader.
Common postambles include cursor controls such as tabs or carriage return
line feeds.
Note: A postamble is not added to scanned data when you run IRL programs.
Default: <CR>
Syntax: AEdata
Acceptable values for data are up to 25 ASCII characters. If you enter the AE
command without data, the postamble is disabled. You must enclose the data
within quotation marks if the data is a reserved word, such as a reader
configuration command (see the example).
Scan: To disable the postamble, scan this bar code:
Disable Postamble
*$+AE*
*$+AE*
To set the postamble to an ASCII character string:
Or:
1. Scan this bar code:
2. Scan a value for data from the "Full ASCII Bar Code Chart" in Appendix C.
3. Scan this bar code:
12-78
Enter Accumulate Mode / Set Postamble
*+/$+AE*
*+/$+AE*
The postamble can be from 1 to 25 characters.
Exit Accumulate Mode
*-/*
*-/*
BC
N F