Intermec Janus 2020 User Manual page 306

JANUS 2020 Hand-Held Computer User's Manual
Operating the Reader (continued)
Problem
The reader appears to be locked up or is
beeping every 10 seconds. When you
press to turn off the reader, it does not
turn off.
All the files on drive E have been erased.
10-10
BC
N F
Solution
Press - - to turn off the reader. It may take a few
seconds before the reader turns off. When you press
on the reader, it displays the Boot Loader menu.
Read the status messages at the bottom of the menu. If the
messages tell you to resume, choose Resume from the Boot
Loader menu. If the messages tell you to reboot, choose Reboot
from the Boot Loader menu to cold boot the reader. You may be
able to save the contents of the physical RAM drive. For help,
see "Saving the Contents of the RAM Drive" later in this
chapter.
Caution
When the reader performs a cold boot, all files on the
physical RAM drive are destroyed.
Conseil
Lorsque le lecteur effectue un amorçage à froid, tous les
fichiers présents sur le lecteur de la mémoire RAM
physique sont supprimés.
The contents of drive E, the physical RAM drive, are destroyed
when you perform these tasks:
You cold boot the reader.
•
• You load the reader's flash memory.
• You put the reader in Storage mode.
• You execute CONFIG.SYS after changing the command that
creates the RAM drive.
• You turn off the reader (by pressing
NiCad battery pack) while the reader is performing a warm
boot.
• You removed and replaced a discharged NiCad battery
pack, instead of inserting a fully charged battery pack.
• You run an application on the reader that masks the
non-maskable interrupt (NMI). While this is acceptable on a
PC, it is not acceptable on a reader.
You must restore or copy your files to the RAM drive E.
to turn
or removing the