Intermec Janus 2020 User Manual page 307

Operating the Reader (continued)
Problem
The reader displays the Boot Loader
menu.
You need to cold boot the reader and you
want to save the contents of drive E, the
physical RAM drive.
NF
Solution
The reader displays the Boot Loader menu in response to
several error conditions:
You turned off the reader (by pressing
•
NiCad battery pack) while the reader was performing a
warm boot.
• You removed and replaced a discharged NiCad battery
pack, instead of inserting a charged battery pack.
• You ran an application on the reader that masks the
non-maskable interrupt (NMI). While this is acceptable on a
PC, it is not acceptable on a reader.
• There may be another problem with the reader.
Read the status messages at the bottom of the menu. If the
messages tell you to resume, choose Resume from the Boot
Loader menu. If the messages tell you to reboot, choose Reboot
from the Boot Loader menu to cold boot the reader. You may be
able to save the contents of the physical RAM drive. For help,
see "Saving the Contents of the RAM Drive" later in this
chapter.
Caution
When the reader performs a cold boot, all files on the
physical RAM drive are destroyed.
Conseil
Lorsque le lecteur effectue un amorçage à froid, tous les
fichiers présents sur le lecteur de la mémoire RAM
physique sont supprimés.
For help, see "Saving the Contents of the RAM Drive" later in
this chapter.
10
BC
Troubleshooting
or removing the
10-11