Sel (Select) - Intermec Janus 2020 User Manual

SEL (Select)

Purpose: Defines the character that requests permission for the controller to send data to
the polled device.
Note: You must select the communications port and protocol before you set the
parameters that define the protocol. For help, see "Communications Protocol,
Configure" earlier in this chapter.
Default: Disabled
Syntax: HAdata
where data can be any ASCII character.
Scan: To disable SEL, scan this bar code:
Disable SEL
*$+HA*
*$+HA*
Or: To set SEL to an ASCII character:
1. Scan this bar code:
2. Scan a bar code for data from the "Full ASCII Bar Code Chart" in
3. Scan this bar code:
NF
Enter Accumulate Mode / Set SEL
*+/$+HA*
*+/$+HA*
Appendix C.
Exit Accumulate Mode
*-/*
*-/*
BC
Configuration Command Reference
12
12-89