Key Code Look-Up Table - Intermec Janus 2020 User Manual

Key Code Look-Up Table

Purpose: You can remap up to 20 scanned characters to a keystroke equivalent.
Default: 102-key PC keyboard (no modifications)
Syntax: WMdata
where data can be any ASCII character.
Scan: To reset the look-up table to the default setting, scan this bar code:
Clear Key Code Look-Up Table
*$+WN*
*$+WN*
Or: To modify any scanned character, complete these steps:
1. Scan this bar code:
2. Scan a bar code for data for the key you want to redefine. Use the "Full
3. Find the four-digit hexadecimal value for the key you want to assign. For
4. Scan a bar code for each digit using the "Full ASCII Bar Code Chart" in
5. Scan this bar code:
NF
Modify Key Code Look-Up Table
*+/$+WM*
*+/$+WM*
ASCII Bar Code Chart" in Appendix C.
Note: Enclose the redefined character and ASCII value in quotes to prevent the
reader from interpreting the option as a reader or configuration command (see the
example).
help, see "Key Codes" in Appendix C.
Appendix C.
Exit Accumulate Mode
*-/*
*-/*
BC
Configuration Command Reference
12
12-67