Intermec Janus 2020 User Manual page 217

3. At the reader's DOS prompt, type this command to start Intersvr:
intersvr
Or scan this bar code:
*INTERSVR*
*INTERSVR*
The Interlnk Server Status screen appears, but no information is displayed
because the connection has not been made yet.
4. On the host computer, press Ctrl-Alt-Del to reboot and load Interlnk from
the CONFIG.SYS file.
Note: After you modify CONFIG.SYS and reboot your host computer once, you
no longer need to reboot to establish a connection. Instead, you can type
interlnk at the host computer's DOS prompt.
5. On the reader, the Interlnk Server Status screen is updated with
information about the redirected drives. Use the viewport to view the
screen. For help, see "Interpreting the Server's Status Screen" later in this
chapter.
You are ready to start using your Interlnk connection. For example, if the
client's drive E is redirected to the server's drive C, type this command at the
client's DOS prompt:
e:
Any command you type at the client's drive E prompt will affect the server's
(reader's) drive C.
BC
NF
Networking the Reader
6
6-31