Eor (End Of Record) - Intermec Janus 2020 User Manual

EOR (End of Record)

Purpose: Attaches an EOR to the end of every record of a file transmit.
Note: You must select the communications port and protocol before you set the
parameters to define that protocol. For help, see "Communications Protocol,
Configure" earlier in this chapter.
The configured option may be overridden when you use certain communications
protocols. EOR will not be overridden when you use User-Defined protocol.
Default: Disabled
Syntax: FBdata
where data can be one or two ASCII characters.
Scan: To disable EOR, scan this bar code:
Disable EOR
*$+FB*
*$+FB*
Or: To set the EOR character to an ASCII character(s):
1. Scan this bar code:
2. Scan one or two bar codes for data from the "Full ASCII Bar Code Chart" in
3. Scan this bar code:
NF
Enter Accumulate Mode / Set EOR
*+/$+FB*
*+/$+FB*
Appendix C.
Exit Accumulate Mode
*-/*
*-/*
BC
Configuration Command Reference
12
12-55