Intermec Janus 2020 User Manual page 122

JANUS 2020 Hand-Held Computer User's Manual
4. Load the reader's CONFIG.SYS file on drive C using Auto-Loader, BFT, or
5. Press
3-32
where:
is the size of the RAM drive in kilobytes; specifies the
disksize
amount of extended memory allocated for the drive. Type a
number from 16 to 256; the default is 64. You can create
multiple RAM drives if the sum of their disksizes is 256K or
less.
Note: You may be able to use more than 256K of extended
memory for the RAM drive. For help, see the previous section,
"Deciding How Much Memory to Use for RAM Drives."
sectorsize is the size of the disk sector in bytes. Type 128, 256, or 512;
the default is 512. You can specify sectorsize only if you
specify disksize.
is the maximum number of files and directories you can
entries
create in the RAM drive. Type a number from 2 to 1024; the
default is 64. You can specify entries only if you specify
sectorsize and disksize.
Here are sample SRAMDISK.SYS commands:
• To create a 64K RAM drive:
device=d:\sramdisk.sys
• To create two 128K RAM drives:
device=d:\sramdisk.sys 128
device=d:\sramdisk.sys 128
• To create a 256K RAM drive with 128-byte sectors and up to 16 entries
in its root directory:
device=d:\sramdisk.sys 256 128 16
MkImage and PutImage, as described in "Learning How to Change the
Contents of Drive C" earlier in this chapter.
to warm boot the reader. The changes to the RAM drive
are put into effect when CONFIG.SYS executes.
Caution
Do not press any keys while the reader is performing a warm boot or
you may lose data.
Conseil
N'appuyez pas sur des touches pendant que le lecteur se réamorce, sinon
vous pouvez perdre des données.
BC
N F