Intermec Janus 2020 User Manual page 111

where:
is the drive and directory of the file or files to include in the
path
image file. If you do not include a path, the current
directory is used.
filename is the name of the file or files to include in the image file.
You can include multiple path\filename and path\*.* parameters in the
command. The path\*.* parameter loads all the files in a directory. For
example:
loadnew c:\janus\data.txt c:\atadrv\*.* c:\data\*.*
6. The image file is saved as NEWDRV_C\IMAGE\DRIVEC.IMG on the host
computer. The next time you execute the MAKENEW command, this
image file will be overwritten. To protect the image file, you can rename it.
To rename the image file
When you execute a LOAD or MAKE command, Auto-Loader saves a copy of
the drive C image file as NEWDRV_C\IMAGE\DRIVEC.IMG. You can copy
that file to multiple readers.
Auto-Loader overwrites DRIVEC.IMG each time you create a new image file. If
you rename DRIVEC.IMG, it will not be overwritten.
You can also create multiple image files and rename each with a unique name.
For example, you can create an image file for each type of PC card you use in
the reader. Each image file contains a CONFIG.SYS that loads the drivers for
the PC card. When you need to switch PC cards in the reader, you can load the
appropriate image file to the reader:
• NEWDRV_C\IMAGE\C-ATA.IMG
• NEWDRV_C\IMAGE\C-FLASH.IMG
To copy the image file to more than one reader
Note: All the files on each reader's drive C will be overwritten.
1. Connect the reader to the host computer through a communications dock
or optical link adapter. If you use the communications dock, you must
connect the dock to the host computer with a 3-wire (2, 3, and 7) cable for
Interlnk to operate properly.
2. Connect the power supply to the communications dock or the optical link
adapter.
BC
NF
Learning About the Software
3
3-21