Intermec Janus 2020 User Manual page 104

JANUS 2020 Hand-Held Computer User's Manual
3. At the DOS prompt on the host computer, type this command:
4. Wait for the installation procedure to finish and follow any instructions on
The installation creates the C_FILES\COMMON directory that contains the
reader's default AUTOEXEC.BAT, CONFIG.SYS, and AUTOINST.BAT startup
files. You can edit these startup files before loading them onto the reader. Do
not remove or alter clearly commented statements required for Auto-Loader.
The installation also copies eight batch files into the directory you created for
Auto-Loader. The next sections describe how to use five of the batch files:
LOADADD, LOADNEW, MAKENEW, LOADIMG, and LOADXIMG. To learn
how to use the other batch files, see "Auto-Loader Batch Files" in Appendix D.
Because the batch files are customized for the drive and directory where they
are installed, you must reinstall Auto-Loader to move the files. Also, these
batch files are customized for English because you did not specify a country
when you installed Auto-Loader. If you want the reader to operate in another
language, you must install Auto-Loader according to the instructions in
Chapter 8, "Preparing the Reader for International Use."
3-14
source :install [- port ]
where:
is the disk drive where you inserted companion disk 1.
source
port is the number of the host computer's COM port that the
reader is connected to. This parameter is optional; the
default is COM1.
Here are two examples:
• If companion disk 1 is in drive A, the reader is connected to the host
computer's COM1, and you want the reader to operate in English, type
this command on the host computer:
a:install
• If companion disk 1 is in drive B, the reader is connected to the host
computer's COM2, and you want the reader to operate in English, type
this command on the host computer:
b:install -com2
the host computer's display.
BC
N F