Intermec Janus 2020 User Manual page 304

JANUS 2020 Hand-Held Computer User's Manual
Operating the Reader (continued)
Problem
The user application is not receiving the
bar code input properly.
The Battery icon appears at the top of the
reader display.
10-8
BC
N F
Solution
Reader Services may have been unloaded. The reader cannot
decode bar code labels unless Reader Services are loaded.
Verify that the IF EXIST D:\RDG.BAT CALL D:\RDG.BAT
command is in AUTOEXEC.BAT, and then warm boot the
reader to reload Reader Services.
If you cannot load Reader Services, you may have assigned too
much conventional memory to the physical RAM drives. For
help, see "Deciding How Much Memory to Use for RAM
Drives" in Chapter 3.
Caution
Do not press any keys while the reader is performing a
warm boot or you may lose data.
Conseil
N'appuyez pas sur des touches pendant que le lecteur se
réamorce, sinon vous pouvez perdre des données.
The reader displays the Battery icon when the NiCad battery
pack has approximately 15 to 45 minutes of power left. If you
are using a J2020, replace the battery pack soon.
If you are using a JR2020, you should immediately replace or
recharge the battery pack because you will soon lose RF
communications.
Caution
When the Battery icon appears, save your data and
replace the battery pack as soon as possible.
Conseil
Quand l'icône de la pile apparaît, enregistrez vos données
et remplacez le jeu de piles aussitôt que possible, sinon
vous pourriez perdre des données.