Command Processing - Intermec Janus 2020 User Manual

Command Processing

Purpose: Command processing allows you to disable or enable reader commands. For
example, you can disable the Backlight command. There are two ways to
enable or disable reader commands:
• Use the Command Processing configuration command described here.
• Use the Reader Commands option on the Op menu in the Interactive
If you want to disable or enable several commands, it is easier to use IC.EXE.
For help, see Chapter 5, "Configuring the Reader."
All reader commands enabled
Default:
Syntax: DCdata
Acceptable values for data are:
0
1
2
3
command0
command1
The override option is a temporary setting that allows you to enable all the
reader commands for as long as you need them. When you want to return to
the previous setting, you disable the override.
Note: If you disable all the reader commands ($+DC0), you cannot change the reader's
configuration or exit from an IRL program. To enable the reader commands again, use
IC.EXE, or edit the configuration "*.ini" file.
Scan: To enable all the reader commands or override the current settings, scan one of
these bar codes:
Disable All Reader Commands
*$+DC0*
*$+DC0*
Disable Override
*$+DC2*
*$+DC2*
NF
Configuration application (IC.EXE) program.
Disable all reader commands
Enable all reader commands
Disable override
Enable override
Disable reader command
Enable reader command
BC
Configuration Command Reference
Enable All Reader Commands
*$+DC1*
*$+DC1*
Enable Override
*$+DC3*
*$+DC3*
12
12-29