Communications Dock Port
Purpose:
Sets the SELPORT signal on the reader's COM1, which selects the port on the
communications dock through which the reader will communicate. When
SELPORT is set to 0, the reader communicates through the dock's network
port. When SELPORT is set to 1, the reader communicates through the dock's
auxiliary port. You use the Communications Dock Port command only when
the reader is in the communications dock.
Network
Default:
Syntax:
IPdata
Acceptable values for data are:
0
1
One of these bar codes:
Scan:
Network Port
*$+IP0*
*$+IP0*
NF
Network port
Auxiliary port
BC
Configuration Command Reference
Auxiliary Port
*$+IP1*
*$+IP1*
12
12-35