Intermec Janus 2020 User Manual page 295

Intermec janus 2020: user guide

Hide thumbs Also See for Janus 2020:

Table of Contents

6. If the Boot Loader menu does not appear, follow these steps to display it:

to turn off the reader.

to turn on the reader.

e. Type the password if the reader prompts you to do so. If you fail to

enter the correct password after three attempts, the reader resumes

normal operation.

7. At the Boot Loader menu, press

to execute the Load command.

9. Insert the Boot Utilities companion disk 1 into a disk drive on the host

10. On your host computer, type the Upgrade command.

Follow this syntax:

source :\upgrade / com_port source : destination :

is the disk drive on the host computer where you inserted

companion disk 1.

is the number of the serial COM port on the host computer

that the reader is connected to.

is the drive on the host computer that you are using as a

temporary work space while installing the loader and flash

files. The drive must have at least 3.5MB of free disk space.

For example, if the disk is inserted in the host's drive A, the host's drive C

is your temporary work space, and the reader is connected to the host's

COM1, type this command on the host computer and press

a:\upgrade /com1 a: c:

Booting and Resetting the Reader

until you select Load.