Transmit Abort Timeout - Intermec Janus 2020 User Manual

JANUS 2020 Hand-Held Computer User's Manual

Transmit Abort Timeout

Purpose: Defines the length of time the reader waits to receive a message if one of these
conditions is true:
• CTS is continuously false for the timeout period.
• XOFF condition does not change within the timeout period.
• POL not received (polling protocol) within the timeout period.
Transmit Abort Timeout is similar to the Timeout Delay configuration, but it
only applies to the three conditions listed above.
Note: You must select the communications port and protocol before you set the
parameters that define the protocol. For help, see "Communications Protocol,
Configure" earlier in this chapter.
Default: Disabled
Syntax: IHdata
Acceptable values for data are:
0
1-65000
Scan: To disable Transmit Abort Timeout, scan this bar code:
Disable Transmit Abort Timeout
*$+IH0*
*$+IH0*
Or: To set a timeout value:
1. Scan this bar code:
2. Scan a numeric value of one to five digits for data from these bar codes:
12-94
Disabled
Timeout in ms
Enter Accumulate Mode / Change Transmit Abort Timeout
*+/$+IH*
*+/$+IH*
*0*
*0*
*2*
*2*
BC
N F
*1*
*1*
*3*
*3*