Using Loadimg; Using Loadnew - Intermec Janus 2020 User Manual

JANUS 2020 Hand-Held Computer User's Manual

Using LOADIMG

LOADIMG loads the image file that you specify on the command line onto the
reader's drive C. LOADIMG overwrites all files currently on drive C.
You must have created the image file already with the MAKENEW,
MAKE_USA, LOADADD, LOADNEW, LOADLANG, or LOAD_USA. You
may have renamed the image file from its default name,
NEWDRV_C\DRIVEC.IMG.
LOADIMG is useful when you are loading an image file onto multiple JANUS
readers.
Here is the syntax for LOADIMG:
where:

Using LOADNEW

LOADNEW creates an image file that contains any files you include in the
command line. If you do not specify startup files in the command line,
LOADNEW adds the three default startup files in C_FILES\COMMON to the
image file. Then LOADNEW loads the image file onto the reader's drive C,
deleting all the files currently on drive C.
If you specified a DOS NLS country when you installed Auto-Loader on the
host computer, LOADNEW appends commands to the AUTOEXEC.BAT and
CONFIG.SYS files to support that DOS NLS language.
Here is the syntax for LOADNEW:
where:
You can specify more than one file or use path\*.* to load all the files from a
directory.
D-14
loadimg path \ filename
path is the drive and directory of the image file to load.
filename is the name of the image file to load.
loadnew path \ filename [ path \ filename path \ filename... ]
path is the drive and directory of the file to load.
filename is the name of the file to load.
BC
N F