Intermec Janus 2020 User Manual page 318

JANUS 2020 Hand-Held Computer User's Manual
Using DOS Commands and Applications (continued)
Problem
The reader does not boot after you
modified the CONFIG.SYS file.
You see this message when you use
Interlnk/Intersrv to copy files between
the reader and the host computer:
Not ready writing drive X
Abort, Fail, Retry
10-22
BC
N F
Solution
Boot the reader and press
"Loading MS-DOS 5.0 ROM Version." The DOS setup screen
appears. Press to make the reader reboot without executing
the startup files.
Correct the error in CONFIG.SYS. Use Auto-Loader, BFT, or
MkImage and PutImage to load the new CONFIG.SYS onto the
reader.
Boot the reader. When you see the DOS message, press
When the DOS setup screen appears, press
should boot with the corrected CONFIG.SYS file.
R
Press to Retry and continue copying the files. You may have
a problem copying files if you use the DOS version (utilities
from your PC) of INTERLNK.EXE and INTERSVR.EXE on the
JANUS reader. Intermec modified the INTERLNK.EXE and
INTERSVR.EXE utilities to work with the JANUS reader. The
Intermec version of these utilities is provided on the reader's
Drive D and on the MS-DOS Programs Companion Disk 2. Use
the INTERLNK.EXE and INTERSVR.EXE utilities provided
with your reader to transfer and copy files.
If you files were not copied correctly, try the procedure again
using the INTERLNK.EXE and INTERSVR.EXE utilities
provided with your reader.
when you see this message,
. The reader
.