Intermec Janus 2020 User Manual page 264

JANUS 2020 Hand-Held Computer User's Manual
3. At the DOS prompt on the host computer, type this command:
4. Wait for the installation procedure to finish and follow any instructions on
The installation creates the C_FILES\COMMON directory that contains the
default AUTOEXEC.BAT, CONFIG.SYS, and AUTOINST.BAT startup files.
You can edit these startup files before loading them onto the reader. Do not
remove or alter clearly commented statements that are required for
Auto-Loader.
The installation also creates eight batch files in the directory you created for
Auto-Loader. You will use LOADADD, LOADNEW, or LOADLANG to
configure the reader to operate in a language. To learn about the other batch
files, see "Auto-Loader Batch Files" in Appendix D.
Because the batch files are customized for the drive and directory where they
are installed, you must reinstall Auto-Loader to move the files. Also, because
the batch files are customized for the language you chose when you installed
Auto-Loader, you must reinstall Auto-Loader to switch to another language.
8-4
source :install [ country ] [- port ]
where:
source is the disk drive where you inserted companion disk 1.
specifies the country that corresponds to the language the
country
reader will operate in. Type a country name supported by
DOS NLS: France, Germany, Italy, or Spain. This parameter is
optional; the default is USA.
port is the number of the host computer's serial COM port that the
reader is connected to. This parameter is optional; the default
is COM1.
Here are two examples:
• If companion disk 1 is in drive A, the reader is connected to the host
computer's COM1, and you want the reader to operate in French, type
this command on the host computer:
a:install france
• If companion disk 1 is in drive B, the reader is connected to the host
computer's COM2, and you want the reader to operate in Italian, type
this command on the host computer:
b:install italy -com2
the host computer's display.
BC
N F