Intermec Janus 2020 User Manual page 219

3. Press to warm boot the reader. A command in the reader's
CONFIG.SYS file automatically loads Interlnk into the reader's memory.
Caution
Do not press any keys while the reader is performing a warm boot or
you may lose data.
Conseil
N'appuyez pas sur des touches pendant que le lecteur se réamorce, sinon
vous pouvez perdre des données.
On the host computer, the Interlnk Server Status screen is updated with
information about the redirected drives. For help, see "Interpreting the Server's
Status Screen" later in this chapter.
You are ready to start using your Interlnk connection. For example, if the
client's drive H is redirected to the server's floppy disk drive A, type this
command at the client's DOS prompt and press
h:
Or scan this bar code:
*H/Z*
*H:*
All commands you type at the client's drive H prompt affect the server's
drive A.
BC
NF
Networking the Reader
:
6
6-33