General Requirements; Country-Specific Requirements - Compaq ServerNet ServerNet II Installation Manual

The power cord set meets the requirements for use in the country where you purchased your
equipment. The voltage selection switch allows you to select the appropriate line voltage for
your server.
Power cord sets for use in other countries must meet the requirements of the country where you
use the server. For more information on power cord set requirements, contact your Authorized
Compaq Dealer.

General Requirements

The requirements listed below are applicable to all countries:
The length of the power cord must be at least 6.0 feet (1.8 m) and a maximum of 12 feet
I
(3.7 m).
The power cord set must be approved by an acceptable accredited agency responsible for
I
evaluation in the country where the power cord will be used.
The power cord set must have a minimum current capacity and nominal voltage rating of
I
10 A/125 volts AC, or 10A/250 volts AC, as required by each country's power system.
The appliance coupler must meet the mechanical configuration of an EN60320/IEC 320
I
Standard Sheet C13 Connector, for mating with the appliance outlet on the computer.

Country-Specific Requirements

Use the following table to identify the appropriate accredited agency in your country.
Power Cord Set Requirements
Power Cord Set Requirements - By Country
Country Accredited Agency
Australia
Austria
Table C-1
Applicable Note Numbers
EANSW
OVE
C
Appendix
1
1
continued