Compaq ServerNet ServerNet II Installation Manual page 32

16. You can click OK on this screen.
17. Minimize the ServerNet II Installation screen, which you later will need to access to install
the ServerNet II applications. (If you do inadvertently shut it down, you can repeat Step 1
in this section to restart it.)
18. To disable the Adapter driver, follow these steps:
a. Access the Windows Device Manager by right clicking My computer and selecting
Properties/Hardware tab/Device Manager, as described previously
b. From the Device Manager screen, click the + to expand the SAN Adapter directory.
c. Right click on Compaq ServerNet II PCI Adapter, and, from the drop-down menu that
appears, select Disable. The following screen appears:
d. Click Yes to disable the Adapter driver (you will re-enable it in the next steps).
NOTE: The Adapter should appear with an
shows Compaq ServerNet II PCI Adapter, Rev3 Board, Rev5 Co2.
19. To re-enable the Adapter driver, follow these steps:
a. From Device Manager, click the + to expand the SAN Adapter directory.
in front of it when disabled. In this example, Step 19
Installing Drivers and Software 2-9