Snetswitchownerchange; Snetswitchfirmwareupgrade - Compaq ServerNet ServerNet II Installation Manual

snetSwitchOwnerChange

ServerNet II Switch SANMan Change. The Switch detected that a new primary
SANMan has taken ownership.
Specific Trap:
Severity:
Summary:
Enable:
Disable:
snetSwitchSnetID
snetSwitchName
snetSwitchSANManSNetID
SANMan failed over
Administrator changed primary SANMan

snetSwitchFirmwareUpgrade

A firmware upgrade has been performed on the specified switch and the switch has
detected that its firmware upgraded completed successfully.
Specific Trap:
Severity:
Summary:
Enable:
Disable:
Returned Variable
snetSwitchSANManSNetID
snetSwitchSnetID
snetSwitchName
snetSwitchFWRelease
snetSwitchFWMajorRev
snetSwitchFWMinorRev
The switches firmware has been upgraded
106
Minor
Switch snetSwitchSnetID, (snetSwitchName), SANMan takeover by
snetSwitchSANManSNetID.
snetSwitchTakeoverTrapEnable = 1
snetSwitchTakeoverTrapEnable = 0
Returned Variable
Possible Cause
107
Information
Switch snetSwitchSnetID, snetSwitchName has been upgraded by SANMan
snetSwitchSANManSNetID. Firmware release snetSwitchFWRelease,
snetSwitchFWMajorRev, snetSwitchFWMinorRev.
snetSwitchSWFWTrapEnable = 1
snetSwitchSWFWTrapEnable = 0
Possible Cause
ServerNet II Switch SNMP Traps J-9
Indicates
Identifies the switch that detected the ownership change
The switch name. If no name is defined, this field will be blank.
New SANMan ID
Possible Solution
Possible node failure
Notification only – not a problem
Indicates
Identifies the SANMan which requested the upgrade.
Identifies the switch that received the firmware upgrade
The switch name. If no name is defined, this field will be blank.
Indicates the firmware release
Indicates the firmware major revision
Indicates the firmware minor revision
Possible Solution
No solution necessary